Minipack Blade Holder Front/Side Bar Kit S03A0310 FM77sc FM77Digit Etc
FM050114 & FM050115
Our Part Number GP00050
Often Called Sealing Infills, Blade Holders, Sealing Beds Etc
They are made from Silicone Glass and often names such as Thermalite & PGM are used when searching for them
They are not cheap which is dictated by the material used with its high temp rating and the difficult slot to machine ito them
It is important with these machines to have the sealing system in good operational condition, the blade should fit snug into the slot with about 1mm protruding, the slot should not be worn so the blade ca lay over to its side, nor should the slot be worn so the blade drops to low
If the "Sealing Infills" are in poor condition you will have varied problems possibly including, poor seal resulting in splitting or whisping seams, not cutting cleanly, bursting seems or burning to the seal area
Sealing systems should be cleaned using one of our specially made wire brushes and should be lubricated with our formulated sealing silicone gel both available from this shop
